In structured cabling system, Horizontal Cabling refers to laying cables from telecommunication distribution room to workstations, printers and other network equipment on a certain floor of a building. As one of the subsystems of the generic cabling system, how should the horizontal customized twisted pair wire System be installed from china?

means of preparation

Before laying customized twisted pair wire from china, we should prepare the following tools:

(1) Threading device: used to pull cables when laying cables under the floor, on the ceiling or on points

(2) Wire stripper: used to strip off the outer sheath of the cable

(3) Crimping pliers: a tool used to press crystal heads

(4) Cable tie: used to manage cables

Three customized twisted pair wire from china modes

Directly buried pipeline trough of customized twisted pair wire from china

Directly buried pipeline trunking is composed of a series of metal wiring pipes or metal feeder trunking sealed in cast-in-situ concrete. These metal pipes or metal trunking radiate horizontally to the position of the information socket. According to the requirements of communication and power wiring, floor thickness, floor space occupied and other conditions, thick wall galvanized pipe or thin wire pipe may be used for direct buried pipe wiring. This approach is very common in old-fashioned designs.

First route trunking and then route branch pipe of customized twisted pair wire from china

The trunking is made of metal or flame-retardant high-strength PVC materials, and there are two types of single piece fastening and closing.

Trunking is usually hung in the area above the ceiling, which is used in large buildings or where the wiring system is complex and requires additional support. Use crossbeam type trunking to lead the cable to the area to be routed. The cable from the weak current well goes through the trunking in the ceiling first. After reaching a room, the cable is branched from the beam type cable duct through the branch trunking and then led to the wall column or wall through a section of branch pipe, and then goes down to the information exit of this floor (or goes up to the wall, and drills a hole in the floor of the previous floor to lead the cable to the information exit of the previous floor); The rear end is connected to the user's socket.

Ground trunking method of customized twisted pair wire from china

The ground trunking method is that the wires from the weak current well go through the ground trunking to the ground outlet box, or the branch pipes from the junction box to the information outlet on the wall. Since the ground outlet box or junction box or column directly goes through the ground cushion, this method is suitable for large bays and occasions requiring partition.

The ground trunking method is to punch the rectangular trunking in the ground cushion, and set a junction box or outlet box every 4 ~ 8 Milla (the outlet box on the branch plays the role of a junction box) until the outlet box at the information outlet.